Colortran I 48 User Manual download pdf (Page 242)

Colortran Encore Control Console

Software Version 3.05

228

? EXAMPLE: To adjust the rate of all cue fades that are currently

fading on playback faders:

1. [RATE] [ENTER]

2. Adjust rate with the wheel by increasing or decreasing fade time.

3. [CLEAR] (Releases rate control

from the wheel.)

When you use the wheel as in the Example above, you increase or decrease the

fade time of all active fades proportionally. When you release rate control with

the [CLEAR] key, the adjusted fade times remain for the fades. You can

readjust the rate by capturing rate control again in the same manner.

If there is more than one fade occurring at the same time, and you want to

adjust the rate of selected cue fades, you can specify the playback fader numbers

that contain the fades you want to control.

? EXAMPLE: To adjust the rate of cue fades that are fading on specific

playback faders:

1. [RATE] [fader # list] [ENTER]

2. Adjust rate with the wheel by increasing or decreasing fade time.

3. [CLEAR] (Releases rate control

from the wheel.)

Note that if you adjust the fade rate of a cue that has an effect fading in or out,

the fade rate of the cue effect is adjusted along with the fade rate of the cue.

? NOTE: Do not confuse the fade rate of a cue effect with the effect

rate.

Changing Submaster Effect Rates

While an effect is running on a submaster, you can adjust the effect rate with

the [RATE] key.

? EXAMPLE: To adjust the rate of all effects that are currently running

on submasters:

1. [RATE] [SUB] [ENTER]

2. Adjust effect rates with the wheel.

3. [CLEAR] (Releases rate control

from the wheel.)

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 293 294

No comments

Colortran I 48 User Manual Page 242