Colortran I 48 User Manual download pdf (Page 268)

Colortran Encore Control Console

Software Version 3.05

D-2

Enabling MIDI

You must enable the Encore MIDI control interface before any commands can

be sent or received.

? EXAMPLE: To enable MIDI control in the Setup display:

1. (SYSTM SETUP)

2. (MIDI CNTRL) ("Device #" appears in MIDI

Control field.)

When you enable MIDI control, the MIDI Command History window appears

in the Playback display, just above the Playback Fader Boxes. The window

shows the last two received MIDI commands in the RCV column, and shows

the last two transmitted commands in the XMT column. MIDI control may be

enabled or disabled at any time during console operation.

Figure C-1 MIDI Command History Window

You can use the (MIDI DEV #) soft key (available under the (SYSTM SETUP)

soft key in the Setup display) to set the MIDI channel device number. Since

Standard MIDI messages are transmitted only when the device number is set to

any of the first 16 channels, you should set the MIDI channel device number

from 1 - 16 when you want to use Standard MIDI messages. For the Encore to

communicate with another device, the two devices must be set to the same

channel.

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 293 294

No comments

Colortran I 48 User Manual Page 268