Colortran I 48 User Manual download pdf (Page 258)

Colortran Encore Control Console

Software Version 3.05

A-4

1. Obtain the correct replacement battery, which can be purchased from

your Colortran dealer as

part # 35-00008 (3 VDC 560 mA/hr Lithium). You can also purchase a battery

from your local electronics retailer (Panasonic model CR2354, or equivalent).

2. First, unplug the console from the AC power source!

3. Place the console on a flat sturdy surface.

4. Using a flat blade screwdriver, loosen the large screws on each side of

the console. (The screws are spring loaded "captive" screws - they cannot fall

out.)

5. Lift the front of the top panel, and raise it to its fully upright position.

Support the top panel with the "hood prop" (located inside the edge of the top

panel) by inserting the end of the hood prop into the hole provided in the edge

of the chassis.

Engine Cover

Thumb Screws

DANGER

High

Voltage

Inside the Encore console

J13

Output

Protection

Module

Inset - under Engine Cover

Battery

Figure A-1, Inside the Console

6. Remove the 4 hand screws from the Engine cover as shown. These

screws are not captive. Take care not to lose the lockwashers on the hand

screws. (The lockwashers are required to maintain the UL safety compliance.)

Locate the battery as shown.

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 293 294

No comments

Colortran I 48 User Manual Page 258